What Size Base Do You Need for a Rotary Washing Line?
The most important thing to check is the diameter of your rotary washing line pole.
Do not choose a base just because it says it can hold a parasol. Measure your rotary washing line pole first and compare the measurement with the base’s pole opening.
For example, if your rotary washing line has a 32mm pole, a base designed for 38mm–48mm poles may not hold it properly without a suitable sleeve or insert.
You should also consider the weight of the base. A small 9kg or 10kg base may be fine for a lightweight setup, but a large rotary washing line with lots of wet clothes can place much more load on the base.
Are Parasol Bases Safe for Rotary Washing Lines?
Parasol bases are not specifically designed for rotary washing lines, so you should use caution.
A rotary washing line can experience sideways movement, especially when clothes are hanging from the lines or when there is wind. A base that works well for a parasol may therefore not provide the same stability for a rotary airer.
For permanent outdoor use, a proper rotary washing line spike installed securely in the ground is generally a more suitable setup.
If you still want to use a base, make sure:
- The pole fits securely inside the base.
- The base is heavy enough for your setup.
- The rotary washing line is not overloaded.
- You avoid using it in strong winds.
Rotary Washing Line Base vs Spike
A rotary washing line spike is designed specifically to hold a rotary washing line pole in the ground. It is usually the better option if you have a suitable garden area where you can install one.
A base can be useful when you cannot or do not want to put a spike into the ground. However, you need to pay more attention to stability because the whole base sits above the ground.
If you need to move your washing line regularly, a portable washing line may be more suitable than trying to use a heavy parasol base.
How to Make a Base for a Rotary Washing Line at Home
Yes. If you want to make a DIY base for a rotary washing line at home, the easiest and strongest option is a concrete base with a metal or plastic sleeve in the centre.
You will need:
- Cement
- Sand and gravel
- Water
- A strong PVC or metal pipe, slightly wider than the pole
- Spade
- Bucket or mixing tray
- Spirit level
- Tape measure
7 steps to make a base for your rotary washing line
- Choose the location: Pick a flat area with enough space for the rotary washing line to open fully.
- Dig a hole: Make a hole around 40–50 cm deep and about 25–35 cm wide. The exact size depends on the size and weight of your rotary line.
- Make the sleeve: Put a strong PVC or metal pipe vertically in the centre. The rotary washing line pole should fit inside it, but not be too loose.
- Mix the concrete: Mix cement, sand, gravel and water until you have a firm concrete mixture.
- Fill around the sleeve: Pour the concrete into the hole while keeping the sleeve perfectly vertical. Check it with a spirit level from different directions.
- Let it cure: Leave the concrete to harden properly. Do not put the rotary washing line in it immediately. Ideally, allow several days before putting a heavy line under load.
- Fit the washing line: Once the concrete is properly cured, place the rotary washing line pole into the sleeve.
View Comments